How Long For Fitech To Learn?

What does reset idle learn on fitech EFI mean?

  • Reset Idle Learn = The Idle Air Learning can be reset to a default value (16 steps) – by setting this control value to 1, and turning the key off and waiting for the system to completely power down. This can be done if the IAC learned incorrect values from an improper throttle adjustment, or other situation that caused the learning to be wrong.

How do I set up my FiTech?

FiTech EFI – Basic Setup Instructions

  1. Resetting to a Stock Calibration. From the main menu, go to the very bottom and select Write Cal To ECU.
  2. IAC Steps.
  3. Reset Learn.
  4. Data Logging.
  5. Save Your Current Settings and Tune.
  6. Cranking Fuel Adjustments.
  7. Accel Pump/Fast Accel Adjustment.
  8. Hesitation.

How much fuel pressure does a FiTech need?

You may wonder why no fuel pressure regulator is used. That’s because the FiTech System throttle body contains an internal fuel pressure regulator that maintains fuel pressure into the system at a constant 58 or 43 PSI depending on your system.

How do I turn off PWM on FiTech?

Step 2: go to main menu, scroll down to option 4: Go EFI Initial set-up, click the joystick to enter. Up Enter Down Page 2 Step 3: go under option 1: engine setup. Then, scroll down to option 6 (pump PWM/FCC ) and select edit, press clear (CLR) and enter a new value.

You might be interested:  How To Learn Active Directory? (Question)

How would you set the base idle speed on a mechanically operated throttle body?

SETTING ENGINE IDLE SPEED Turn idle speed screw counter-clockwise until the throttle butterfly is fully closed. Then continue to turn idle speed screw counter-clockwise until you can see between the screw and stop (or if using a feeler gauge -. 010″) then turn clockwise one full turn.

Where is FiTech made?

FiTech, a new American company based in Riverside, California, is the brainchild of Ken Farrell and Jeremy Schmidt.

What is hanging idle?

Most people say without any mechanical issues, a hanging idle usually means you’re running lean in your idle, or even partial throttle circuit. Found a few sources claiming a hanging idle can also occur when you’re too rich, because of excess unburnt fuel.

How do I reset my Fitech?

To reset the learn is a very easy procedure. Go into the Go EFI Initial setup then find Reset Learn. Once in that menu find Reset All Learn, highlight this and push right on the joy stick to go to #1, then save that to the ECU by pressing IN on the joystick.

Does FiTech need a return line?

You NEED a return regardless with an inline pump fuel system. It comes down to if you are returning from a remote mount regulator or from the built on regulator.

What happens when you have too much fuel pressure?

Too high of pressure may result in, over fueling of the engine. As a result, this can lead to a rough running engine; poor fuel mileage, and black smoke coming from the exhaust. If your regulator is going bad, your car could display several different symptoms.

Leave a Reply

Your email address will not be published. Required fields are marked *